VinawoodVinawood *

„Plywood Standard Sizes and Dimensions: A Global Manufacturer's Guide“ ist in Deutsch noch nicht verfügbar

Wir haben diese Seite noch nicht übersetzt. Durchsuchen Sie alle unsere Blog unten — wir übersetzen bald mehr Inhalte.

Alle Blog anzeigen

Curated by Vinawood

Dive Deeper Into This Topic

Related Reading

Quick Answers

What is the standard size of film-faced formwork plywood?
Film-faced formwork plywood is pressed in two main sheet formats: 1220 × 2440 mm, the metric form of 4 × 8 ft used across North America and many Asian and Middle East programmes, and 1250 × 2500 mm, the format European frame systems are built around. Our film-faced grades run 12 to 21 mm in both formats, and Pro Form also goes up to 30 mm in the European size. Lock the format on the RFQ so the sheets drop into the frames without a saw.
Why is plywood 4 feet by 8 feet?
The 4 × 8 ft sheet, or 1220 × 2440 mm, exists because North American framing grew up on 16 inch and 24 inch spacing, so a full panel lands on studs and joists without waste. Formwork followed the same module, which is why wall and deck forms in the US and Canada are sized around it. Europe settled on 1250 × 2500 mm instead, because that is the panel its modular system frames were built to take.
What thickness plywood do I need for formwork?
Most wall and slab forming runs on 18 mm, while 12 mm and 15 mm sheets suit lighter work or close support spacing, and 21 mm is there for heavier pours or wider spans. In the European format, Pro Form also comes at 24, 27 and 30 mm, and the HDO Standard HD 1SF goes to 25 mm in the North American format. Choose thickness for pour pressure and support spacing, then keep one grade and one thickness on an exposed wall so joints stay even.
Are plywood sheet sizes exact?
Nominal size is the ordering figure, not a guarantee that every edge is dead on. Our product data holds length and width to 1 mm per metre, so a 2440 mm sheet stays within a couple of millimetres of nominal, and thickness follows the EN 315 tolerance that applies to CE-marked plywood under EN 13986. That gap matters when panels butt in a system frame, because a thick sheet next to a thin one can print a line on exposed concrete.
Can I order custom plywood sizes?
Yes, if the format is one we press, or if we can confirm a special size on the RFQ before you order. Our product data already lists half-width system formats such as Pro Form at 1220 × 625 mm in 15 mm and high-density Pro Form at 2500 × 625 mm in 21 mm, which saves a crew from ripping full sheets on site. Ask rather than assuming a size outside this list, because a container of sheets the frames will not take is costly to correct.
Which Vinawood formwork grades come in which sheet format?
The film-faced range is pressed in both 1220 × 2440 mm and 1250 × 2500 mm. HDO is pressed in 1220 × 2440 mm only, from 12 to 25 mm depending on the grade. MatteFace Plywood, our matte phenolic film panel, comes in both formats at 12, 15, 18 and 21 mm.